WiFi Adapter Kit For Light-O-Rama CTB16PC Controllers Version 2.0

$35.00

Eliminate the need to run cables to your remote boxes by adding this WiFi adapter to your setup.

In stock

SKU: BC-WIFI-NOG3v2 Categories: ,

Description

Version 2.0 has fewer components required for the build and is a bit smaller than the previous version.

Eliminate the need to run cables to your remote boxes by adding this WiFi adapter to your setup. This works great for setups where an ethernet cable is not practical such as a display that crosses a road between neighboring houses.

The board is simply plugged into the 18-pin header at the right of the board, and a short patch cable (included) is used to connect to the board. With this setup you can still daisy-chain additional controllers.

The adapter comes as a kit and includes the Ethernet patch cable and programmed wireless board so that there is nothing else to buy.

This version is only for the CTB16PC Light-O-Rama board. To confirm you have this board you should see an 18-pin header at the right of the board and the name CTB16PC silkscreened at the bottom similar to the images below. If your board has the header on the top of the board you will need to purchase the CTB16PCG3 WiFi Controller instead.




Reviews

There are no reviews yet.

Be the first to review “WiFi Adapter Kit For Light-O-Rama CTB16PC Controllers Version 2.0”

Your email address will not be published. Required fields are marked *